Atmospheric boundary layer top height in South Africa: measurements with lidar and radiosonde compared to three atmospheric models
Loading...
Date
Authors
Korhonen, K.
Laakso, L.
Beukes, J.P.
Van Zyl, P.G.
Josipovic, M.
Tiitta, P.
Supervisors
Journal Title
Journal ISSN
Volume Title
Publisher
EGU
Record Identifier
Abstract
Atmospheric lidar measurements were carried out
at Elandsfontein measurement station, on the eastern Highveld
approximately 150 km east of Johannesburg in South
Africa throughout 2010. The height of the planetary boundary
layer (PBL) top was continuously measured using a Raman
lidar, PollyXT (POrtabLe Lidar sYstem eXTended).
High atmospheric variability together with a large surface
temperature range and significant seasonal changes in precipitation
were observed, which had an impact on the vertical
mixing of particulate matter, and hence, on the PBL evolution.
The results were compared to radiosondes, CALIOP
(Cloud-Aerosol Lidar with Orthogonal Polarization) spaceborne
lidar measurements and three atmospheric models that
followed different approaches to determine the PBL top
height. These models included two weather forecast models
operated by ECMWF (European Centre for MediumrangeWeather
Forecasts) and SAWS (South AfricanWeather
Service), and one mesoscale prognostic meteorological and
air pollution regulatory model TAPM (The Air Pollution
Model). The ground-based lidar used in this study was operational
for 4935 h during 2010 (49% of the time). The PBL
top height was detected 86% of the total measurement time
(42% of the total time). Large seasonal and diurnal variations
were observed between the different methods utilised.
High variation was found when lidar measurements were
compared to radiosonde measurements. This could be partially
due to the distance between the lidar measurements
and the radiosondes, which were 120 km apart. Comparison
of lidar measurements to the models indicated that the
ECMWF model agreed the best with mean relative difference
of 15.4 %, while the second best correlation was with
the SAWS model with corresponding difference of 20.1 %.
TAPM was found to have a tendency to underestimate the
PBL top height. The wind speeds in the SAWS and TAPM
models were strongly underestimated which probably led to
underestimation of the vertical wind and turbulence and thus
underestimation of the PBL top height. Comparison between
ground-based and satellite lidar shows good agreement with
a correlation coefficient of 0.88. On average, the daily maximum
PBL top height in October (spring) and June (winter) was 2260m and 1480 m, respectively. To our knowledge, this
study is the first long-term study of PBL top heights and PBL
growth rates in South Africa
Sustainable Development Goals
Description
Keywords
Citation
Korhonen, K. et al. 2014. Atmospheric boundary layer top height in South Africa: measurements with lidar and radiosonde compared to three atmospheric models. Atmospheric chemistry and physics, 14:4263-4278. [https://doi.org/10.5194/acp-14-4263-2014]
